2007 Minnesota Statutes
This is an historical version of this statute chapter. Also view the most recent published version.
299G.14 GLAZING MATERIAL; LABELING REQUIRED.
Subdivision 1. Permanent labeling; identification; standard. Each lite of safety glazing
material manufactured, distributed, imported, or sold for use in hazardous locations, or installed
in such a location within this state shall be permanently labeled by such means as etching,
sandblasting, firing of ceramic material, hot-die stamping, transparent pressure sensitive labels, or
by other suitable means. The label shall identify the seller, manufacturer, fabricator, or installer,
the nominal thickness and the type of safety glazing material, and the fact that said material meets
the test requirements of the American National Standards Institute Standard Z-97.1-1972.
The label must be legible and visible after installation.
Subd. 2. Limited use. Such safety glazing labeling shall not be used on other than safety
glazing materials.
History: 1974 c 53 s 2
Subdivision 1. Permanent labeling; identification; standard. Each lite of safety glazing
material manufactured, distributed, imported, or sold for use in hazardous locations, or installed
in such a location within this state shall be permanently labeled by such means as etching,
sandblasting, firing of ceramic material, hot-die stamping, transparent pressure sensitive labels, or
by other suitable means. The label shall identify the seller, manufacturer, fabricator, or installer,
the nominal thickness and the type of safety glazing material, and the fact that said material meets
the test requirements of the American National Standards Institute Standard Z-97.1-1972.
The label must be legible and visible after installation.
Subd. 2. Limited use. Such safety glazing labeling shall not be used on other than safety
glazing materials.
History: 1974 c 53 s 2
Official Publication of the State of Minnesota
Revisor of Statutes